Locknut socket for OHLINS TTX25 / NIX / FGRT forks
Tool to remove the fork caps / plugs, specific for the following fork :
OHLINS TTX25 / NIX / FGRT
Tinkering with your motorbike often requires basic tools, such as flat spanner, screwdrivers, ratchets, pliers etc etc. However, some 'components' often require specific tools, such as , for example, Suspension.
Whether you want to start maintaining your motorcycle on your own, and apply your mechanical knowledge, we offer basic tools to start tinkering.
Or perhaps you are already equipped with basic tools and now you want to upgrade to specific tools such as those needed to maintain and adjust your suspensions?
This is essential, for example, when it comes to adjusting your preload for a ride where you are going to be riding "loaded", but also before you start replacing your fork gaskets.
In this kind of situation, you will need specific tools that you probably do not have in your toolbox, such as a spanner for pre-loading or a specific sleeve for the fork caps.
You do not have to be an expert mechanic to know that nothing is more annoying than being stuck with the bike nose up in the air, thinking that you will have to leave everything on stand-by or reassemble it due to a lack of adequate tools before you can finish the job.
To avoid and anticipate these inconveniences, AVDB now offers you a whole range of tools to simplify your life... and your mechanics, whether in your garage, in the paddock or sometimes even on the roadside !
These locknut sockets tools are specifically designed to remove your fork caps without damaging anything, and with the greatest ease.
It is very important to carefully check the measurements so that you make no mistake choosing the right model you need.
Our sockets are equipped with an integrated nut so that you can use them with any hexagon spanner size 6 (flat, socket, etc).
A little tip for Sunday handymen :
For disassembly, if you do not have a bench vice to hold the fork tube, then only loosen the upper fork tube bracket so that the lower fork tube bracket can be used as a bench vice. You can then release your cap without damaging anything !
TO REASSURE YOU
- You have a doubt ? You need more informations about the item ? Do not hesitate to contact us by email, we will answer in English within 24 hours.
- The item is available in stock. Otherwise you can not buy it. We ship the box from France within 24 hours after we receive your order. No taxes to pay at delivery if you live in E-U.
- Free shipping for your order if it is more or equal to 100 €.